Telescoping Full-Length Side Rail

Drive Telescoping Full Length Side Rails for beds are constructed of 1" steel tubing for added strength.  Designed to telescope with the movement of the bed, they easily adjusts up or down with a spring-loaded release.  The cross bars are easy to install and requires no tools.  These side rails for beds are finished in an attractive brown vein finish that is easy to maintain.

Instructions for Telescoping Full Length Side Rails for Beds

Make sure the crossbraces are 45 to 72 inched apart.
1. Extended one bed rail to reach the head and foot-end crossbraces.
WARNING: The outer Telescoping tube of the bed rail must be positioned at the Head-end of the bed to
prevent a pinch point when raising/ lowering the bed.
2. Insert the outer telescoping rail into the barrel of the Head-end crossbrace.
3. Pull and hold the spring loaded knob on the Head-end barrel
4. Adjust the bed rail to one of the three positions.
5. Release the spring loaded knob on the Head-end barrel.
6. Raise or lower the bed rail until the spring loaded knob “clicks” securely into the lower or upper adjustment hole or until the rail stop securely rests against the barrel.
7. Insert the INNER telescoping rail into the barrel of the FOOT-END cross brace.
8. Pull and hold the spring loaded knob on the FOOT-END barrel.
9. Adjust bed rail to the position determined in STEP 4.
10. Release the spring loaded knob on the FOOT-END barrel.
11. Raise or lower the rail until the spring loaded knob “clicks” securely into the lower or upper adjustment hole or until the rail stop securely rests against the barrel.
12. Repeat STEPS 1-11 to install the other bed rail onto the opposite side of the bed.